5. Strip the cable as shown then connect the wiring
as per the diagrams below, ensure terminals are
properly tightened and no bare wire is visible.
NOTE: In order to have RF function, mains electricity
must be connected to the Master (first) dimmer
module.
Additional slave units (maximum of 6 in line) will
allow for 2-way / multi-way operation (units can only
be operated manually).
Max: 8mm
Min: 13mm
6. Screw the dimmer switch to the mounting box and
ensure that the screws are sufficiently tight to support
the product, but please do not over tighten as this
may cause some damage. Ensure that the plastic
spacer is correctly aligned and that no wires are
trapped between the dimmer switch and the back of
the wall box.
Summary of Contents for connect JSJS LW240
Page 4: ......
