![background image](http://html1.mh-extra.com/html/light-my-bricks/75953/75953_manual_1911523003.webp)
Cables can fit in between and underneath LEGO® bricks, plates, and tiles providing they are laid correctly
between the LEGO® studs. Do NOT forcefully join LEGO® together around cables; instead ensure they are
laying comfortably in between each stud.
CAUTION: Forcing LEGO® to connect over a cable can result in damaging the cable and light.
Connecting cable connectors to Expansion Boards
Take extra care when inserting connectors to ports of Expansion Boards. Connectors can be inserted only
one way. With the
expansion board facing up, look for the soldered “=” symbol on the left side of the
port. The connector side with the wires exposed should be facing toward the soldered “=” symbol as you
insert into the port. If a plug won’t fit easily into a port connect
or, do not force it.
Summary of Contents for 75953
