Take a White 15cm Bit Light and thread the connector end through the bottom (larger hole) of the trans
yellow cone piece. Thread the light all the way through until the LED is right up inside. Secure the Bit Light
in place by reconnecting the round plate underneath and round plate with tip on top. Ensure the cable is
facing the back of wherever the LED front is facing.
Reconnect the lamp to one of the grey bricks with clips, then bring the cable underneath the base of the
grey brick. Thread the Bit Light cable down the space on
the top left of the professor’s office.
Pull the
cable all the way up from the other side (middle area). Ensuring the cable underneath the grey brick is laid
in between studs, reconnect this section to the wall, then connect the bit light cable to the 6-port
expansion board.
Summary of Contents for 75953
