![background image](http://html1.mh-extra.com/html/light-my-bricks/75953/75953_manual_1911523076.webp)
Neaten up all the cabling on top of the potion classroom by twisting and folding them around
each other into 2 neat bunches. One for the bit lights cables and the other for the connecting
cables. Take the Micro 4-Port Expansion Board and stick it to the top of the back wall using 2x
Adhesive Squares.
Place the flicker effects board flat down on top of the expansion boards, then place the
bunched up cables over the top. Lay any excess cable to the left and right in between studs.
Reconnect all the pieces and sections we removed earlier over the top of the components.
Note
–
that some of the components may still be visible if you look from underneath.
Summary of Contents for 75953
