Liftket STAGEKET, Operating Instructions Manual

Page: 20 / 58

20
3.1.6 Assembling the load chain in single fall version
1. Push the pull-in wire (special tool) into and through the chain guide cross plate as shown in Figure 16-A until the
wire hook is pushed out on the opposite side.
2. Start with a flat chain link (Figure 16-A) and feed the chain end using the pull-in wire into the chain pocket.
3. Move the chain in by inching the control pendant (Figure 16-B).
4. Put the rubber buffer on the chain end and assemble the load hook (Figure 16-C).
5. Lower the load hook until only circa 0.5 m of the dead end of the load chain are left at the dead end side.
6. Attach the rubber buffer for the lift limiter onto the remaining dead end of the chain.
7. Attach the lift limiter onto the 3rd link of the dead end (Figure 16-D) in upright use and 0.5 m away from the end in
case of inverted use.
8. Assemble chain box according to 3.1.5.
9. Allow the chain to run into the chain box and lubricate the entire length of the chain.
Let the dead end of chain run into the chain box by pressing the up button and using the hoist motor to
prevent knots inside the chain box. Allow filling of the chain box only by running the chain through the
hoist by using the motor. To prevent knots inside the chain box do not put the chain in the box directly.
Figure 16-A Figure 16-B Figure 16-C
Figure 16-D Figure 16-E
Figure 16: Assembling the load chain in single fall version