EN
5
PRIMING - BEFORE FIRST USE
1
Unscrew and remove the pump base from the bottle. Fill the
bottle to within 1 inch/2.5 cm of the brim. Screw the pump base
back into place and leave to stand for 10 minutes.
2
After 10 minutes, unscrew the pump base and empty the water
out of the bottle end. Fill the bottle to within 1 inch/2.5cm of the
brim and screw the pump base back into place.
3
Pop open the snap fit lid, then open the nozzle with clean hands or
teeth; hold the bottle over a sink or drain. Turn and unlock the pump
handle and pump the bottle a maximum of 4 times. After a short
time the water will start to flow from the nozzle. Drain this water
away.
PRIMING - BEFORE FIRST USE
4
When flow slows to a dribble, pump another 4 times to increase
water flow, until 1 inch/2.5 cm of water remains in the bottle
when held with the nozzle facing downward.
5
Repeat steps 2 – 4 twice more.
