7
1
3
2
WaTer TesT
Your case has been water tested. If you plan to expose your iPhone to water, it is
recommended that you perform a pre-installation water test. Do not install device
during test.
1. Snap case front and back together.
2. Close charge port door and make sure jack cover is screwed all the way in
3. Submerge in water for 30 minutes
WATER TEST
4.
Submerge underwater,
weighing it down with a coffee cup
for an hour.
4.
After an hour, bring it out of the water
and check that it’s dry inside.
3.
Make sure your charge port door is closed
and your headphone plug is screwed in securely
2.
Align the front and rear cases (no phone)
1.
Check seals are clean and in-place
on the rear case
3. Make sure the Top latch and bottom latch are
totally closed. The Easiest way to do is to put
the front flat on a table and very firmly press
all around the case, on the top and bottom.
30
1
2
TesT d’ÉTanchÉiTÉ À L’eau
Votre étui a fait l’objet d’un test d’étanchéité à l’eau. Si vous prévoyez d’exposer votre
iPhone à de l’eau, il est recommandé d’effectuer un test d’étanchéité avant l’installation.
N’installez pas l’appareil pendant le déroulement du test.
1. Emboîtez les parties avant et arrière de l’étui l’une dans l’autre.
2. Fermez la porte du port de charge et vérifiez que le couvercle de la prise pour
écouteurs est vissé à fond
3. Submergez l’étui dans l’eau pendant 30 minutes
WATER TEST
4.
Submerge underwater,
weighing it down with a coffee cup
for an hour.
4.
After an hour, bring it out of the water
and check that it’s dry inside.
3.
Make sure your charge port door is closed
and your headphone plug is screwed in securely
2.
Align the front and rear cases (no phone)
1.
Check seals are clean and in-place
on the rear case
3. Make sure the Top latch and bottom latch are
totally closed. The Easiest way to do is to put
the front flat on a table and very firmly press
all around the case, on the top and bottom.
30
1
2
1
2
30