9
ASSEMBLY INSTRUCTIONS
1. Install the Front and Rear Stabilizers.
Remove two M8x73 Bolts (14), D8 Curve Washers
(15), and M8 Cap Nuts (16) from the Front
Stabilizer (2). Then attach the Front Stabilizer (2)
onto the front curve plate of Main Frame (1) with
two M8x73 Bolts (14), D8 Curve Washers (15), and
M8 Cap Nuts (16) that were removed.
Remove two M8x73 Bolts (14), D8 Curve Washers
(15), and M8 Cap Nuts (16) from the Rear
Stabilizer (3). Then attach the Rear Stabilizer (3)
onto the rear curve plate of Main Frame (1) with
two M8x73 Bolts (14), D8 Curve Washers (15), and
M8 Cap Nuts (16) that were removed.
Adjusting the adjustable leveler:
Turn the Adjustable Levelers (17) on the Rear
Stabilizer (3) as needed to level the bike.
2. Install the Handlebar Post and
Tension
Control Knob.
Install the Handlebar Post Cover (44) onto the
Handlebar Post (4).
Remove four D8 Curve Washers (15) and M8x15
Bolts (45) from the tube of the Main Frame (1).
Insert the Tension Cable (50) through into the
bottom hole of Handlebar Post (4) and pull it out
from the square hole of Handlebar Post (4).
Connect the Sensor Wire II (51) from the Main
Frame (1) to the Sensor Wire I (49) from the
Handlebar Post (4).
Install the Handlebar Post (4) onto the tube of the
Main Frame (1) and secure with four D8 Curve
Washers (15) and M8x15 Bolts (45) that were
removed.
Remove the D5 Curve Washer (47) and M5x50
Bolt (48) from the Tension Control Knob (46). Put
the cable end of resistance cable of Tension
Control Knob (46) into the spring hook of Tension
Cable (50). Then pull the resistance cable of
Tension Control Knob (46) up and force it into the
gap of metal bracket of Tension Cable (50) as
shown in small drawing 1 to 4 of figure 2. Attach
the Tension Control Knob (46) onto the Handlebar
Post (4) with the D5 Curve Washer (47) and M5x50
Bolt (48) that were removed.
1
2
14
15
16
17
3
14
16
15
15
16
1
50
46
49
4 3 2 1
50
46
50
48
47
4
1
49
51
44
15
45
15
45
2
