12
S
TRIDE
S
ENSOR
A
UTO
-S
HUTOFF
S
YSTEM
The Stride Sensor auto-shutoff system detects whether a user is on the belt/deck. If the user
leaves the belt/deck during a workout, the system is triggered and the following message is dis-
played, "User not detected on belt - press enter to continue workout." If the user presses enter
during this message the workout will continue without interruption. If the user does not press
enter another message will be displayed, "User not detected on belt - press enter to resume
workout" at this point power to the belt will shut off as the treadmill enters Pause mode. If the
user presses ENTER during the second message the workout will be resumed. If the user does
not press ENTER, the treadmill will continue in Pause mode and eventually end the workout.
This feature can be disabled in the Manager's Configuration.
F
ITNESS
N
ETWORKING
The two interchangeable type RJ45 networking ports (A) are located on the back of the display
console. These network ports, located behind the display console rear access door, allow the
treadmill to be connected to a fitness entertainment system and/or a fitness network, such as
FitLinxx®.
•
Networking:
The built-in networking ports allow the unit to exchange workout
information with a fitness network database.
•
Fitness Entertainment:
The built-in network ports allow the treadmill to power a
third-party receiver for use with an entertainment system, such as the Cardio Theater®
system, BroadcastVision
TM
or Enercise
TM
.
A
