5
SPEED
Press
the red LED
(SX)
switches on.
Press
and
to set the various speed values.
Minimum
LEDS ON
SPEED
5.1
Obstacle detection
The automation is fitted with an obstacle detection system: the automation inverts its movement when it strikes an obstacle during the opening and closure phases.
Sensitivity regulation consists in greater or lesser rapidity in response to the obstacle.
1) During the closing phase, if the control unit identifies an obstacle, the automation inverts motion and performs complete opening. If the obstacle is
detected 3 times consecutively, the automation stops in a completely open position awaiting a command.
2) During the opening phase, if the control unit identifies an obstacle, the automation performs a short reversal of motion, and after it stops awaiting
a command.
Wait 10 seconds or press
again to quit.
Press
for 5 seconds, the red LED
(SX)
will light and then
switch off.
Press
and
to set the various obstacle detection values.
MINIMUM
MAXIMUM
LEDS ON OBSTACLE DETECTION
5.2
Fuses
5IJTQBSBNFUFSBEKVTUTPQFOJOHBOEDMPTJOHTQFFEPGUIFCBSSJFS
MAXIMUM
Wait 10 seconds or press
again to quit.
#'JTQMBDFEJOTFDPOEBSZUP7WPMUTUPQSPUFDUUIFPWFSMPBEPGUIFUSBOTGPSNFSTFDPOEBSZ
4QFDJmDBUJPOTNJOJBUVSFGVTFY5"DFSUJmDBUF*&$PS&/
"'JTQMBDFEJOQSJNBSZ7WPMUT
4QFDJmDBUJPOTNJOJBUVSFGVTFY5"DFSUJmDBUF*&$PS&/
