4.1
Automatic closing
Automatic closing is activated after a preset PAUSE TIME.
In this mode by pressing the start button or radio transmitter the automation changes it motion as follows OPEN-PAUSE- CLOSE – PAUSE
Wait 10 Seconds or press the time but-ton to quit
Press (top right) and the right green led switches will be on.
Press the button to increase or
the button to decrease the pause time.
4.2
Menù
OPTION 1
4.3
Menù
OPTION 2
5”
LEDS
OPTION 1
CLOSING PASSING BY: passing by the
photocells (PHOTO), the automation closes after 2”.
,
LEDS
OPTION 2
Press the option button (bottom right) once, then press in sequence to scroll through the options as shown by the led’s at the top.
The flashing of the led indicates the option selected. The + button is used to select the function indicates by the led staying lit without
flashing. The - button will de select the option, led off.
Press
5
seconds, then press in sequence to scroll through the options as shown by the five led’s at the top. The flashing of the led
indicates the option selected. The + button is used to select the function indicated by the led staying lit.
The – button will de select the option.
To exit continue to scroll through to option 5
.
NO FUNCTION IS ACTIVE.
Condominium: command step only opening
Operatine Mode: Open-Stop-Close-Stop.
Pre-flash
Flashing Paused.
NO FUNCTION IS ACTIVE
.
If no leds are on the automatic closing is not enable
LED
1 s
5 s
10 s
15 s
20 s
30 s
45 s
65 s
100 s
130 s
Scala 1
Scala 2
"%+645.&/5"/%015*0/4
1SFTTJOTFRVFODFUPBDUJWBUFUIFEFTJSFEUJNFBOETXJUDIGSPNTDBMFUPTDBMFXJUI-&%POTDBMFXJUI-&%TPOTDBMF
PAUSE TIME
"650."5*$3&$-0463&*4/05&/"#-&%
Increased slow down position in OPENING
Increased slow down position in CLOSING
Change function RELAY 1 in STEP BY STEP
Change function RELAY 2 in TRAFFIC LIGHT
..................................
