FCC Compliance Information
Before using this product, it is essential to read this ENTIRE operation manual and ALL assembly instructions. It describes
equipment setup and instructs members on how to use it correctly and safely.
FCC Warning - Possible Radio / Television Interference
EN ISO 20957 Class S: Professional and / or commercial use.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses and can radiate
radio frequency energy, and if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
EN ISO 20957 Class H: Home use.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and if not
installed and used in accordance with the user manual, may cause harmful interference to radio communications.
However, there is no guarantee that the interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Any changes or modifications to this equipment could void the product warranty.
Any service, other than cleaning or user maintenance, must be performed by an authorized service representative.
Bikes:
For EN ISO 20957-5: 2016 Class SA accuracy testing, power at the crankshaft was measured by connecting the training
equipment to a dynamometer. The crank was rotated and torque measured per EN ISO 20957-5: 2016 Class SA operating
test conditions. Accuracy of the resulting watts displayed on the console and actual watts measured by dynamometer
were found to be within the tolerance of EN ISO 20957-5: 2016 Class SA (+/- 5 Watts up to 50 Watts and +/- 10% over
50 Watts).
Arc Trainers and Cross-Trainers:
For EN ISO 20957-9: 2016 Class SA accuracy testing, power at the crankshaft was measured by connecting the training
equipment to a dynamometer. The crank was rotated and torque measured per EN ISO 20957-9: 2016 Class SA operating
test conditions. Accuracy of the resulting watts displayed on the console and actual watts measured by dynamometer
were found to be within the tolerance of EN ISO 20957-9: 2016 Class SA (+/- 5 Watts up to 50 Watts and +/- 10% over
50 Watts).
Page 6 of 44
