LIFAN Power USA LF4250EPL, Operating Instructions And Owner'S Manual

Page: 29 / 54

28
Storing the Unit
STORAGE
Before long term storage of your power equipment product, typically 30 days or more, perform the following:
1. Set the fuel cock (valve) to the “OFF” position.
2. Let the unit continue to run until it stops itself, burning all of the fuel in the fuel system.
3. Turn the ignition switch to the “OFF” position.
4. Drain the engine oil in accordance with the “Oil Change Procedures” in this Owner’s Manual’s Maintenance
section. Do NOT re-‐‐fill with oil until ready to use again.
5. Remove the Spark Plug in accordance with the “Spark Plug Maintenance” in the Owner’s Manual’s
Maintenance section. Spray a lubricant, such as WD40®, into the Spark Plug hole to lubricate the top of the
piston and walls of the cylinder. Replace the Spark Plug.
6. Pull starter rope until resistance is felt. This will place the valves in the closed position.
7. Add the recommended amount of fuel stabilizer, in accordance with the amount recommended by the
manufacturer of the fuel stabilizer, to the unused gasoline left in the fuel tank.
8. Place the unit in a clean, dry, and secure location.
9. Your Electric Start Model is equipped with a 5a Trickle Charger Built in, simply plug it into the T type
recepatacle on the control panel and a 110v receptacle to maintain or recharge your battery.
10. Cover with “LIFAN Water Proof Generator Cover,” Item Number LF100-‐‐69600 not included) or
canvas/vinyl tarpaulin. Do NOT operate unit with cover installed.