LIFAN Power USA LF4250EPL, Operating Instructions And Owner'S Manual

Page: 26 / 54

25
Operation of Generator
HOW TO USE YOUR GENERATOR
ELECTRICT START MODELS:
5. For Electric Start Models, push the rocker switch to the “ON” position. Push rocker switch to start position
and hold until engine starts or for NO MORE than 10 engine rotations. If the engine does NOT start, wait 15
seconds and repeat starting procedures.
6. Once the engine runs for 3-‐‐5 seconds, push the choke pin in to disengage.
NOTE (all models): If generator does not start within FIVE pulls, check the crankcase oil level. The engines “Low
Oil Alarm System” may be activated and preventing the engine from starting.
CONNECTING ELECTRICAL LOADS:
1. Ensure engine is started before plugging in any electrical appliance.
2. Plug in desired 120 Volt loads to the 120 Volt U-‐‐Ground and 240 Volt loads to the 240 Volt receptacles.
Always plug appliances into the generator with appliance in its “OFF” position.
3. Do NOT connect 240 Volt loads to the 120 Volt receptacles.
4. Only connects single-‐‐phase 60 Hertz loads.
5. DO NOT OVERLOAD THE GENERATOR. FOLLOW THE PROVIDED “GENERATOR WATTAGE REFERENCE
WORKSHEET” TO DETERMINE THE RUNNING AND STARTING WATTAGE OF YOUR EQUIPMENT REFER TO
THE PRODUCT SPECIFICATIONS TO ENSURE YOUR GENERATOR WILL OPERATE THE DESIRED
EQUIPMENT.
NOTE: Use the running and starting wattage provided by the equipment manufacturer if available. If not
available, use provided “Generator Wattage Reference Worksheet.”