16 US-EN
Receiver (see Fig. B):
Remove the battery compartment cover
6
from the back of the
receiver.
Remove the used battery, if present.
Insert 3 batteries (1.5 V (direct current), type AA).
Note:
Ensure correct polarity. This is indicated in the battery
compartment
8
.
Close the battery compartment cover
6
.
Transmitter:
Remove the name plate from the holder
12
by pressing the lock
11
and remove the rubber cover
16
(see fig. C1).
Remove the used batteries, if present (see fig. C2).
Insert a battery (3 V (direct current), type CR 2032). The side
marked “+” must face up.
Re-install the rubber cover
16
, close the holder
12
of the transmitter
on to the back of the product.
Fasten the holder, and place screw
15
of the transmitter back on
to the back of the product & name plate.
The transmitter battery compartment with the holder must be in-
stalled using the screw
15
while in use. If the holder is damaged,
stop using the product.
Synchronizing transmitter / receiver
The product works on 434 MHz which is a quite common frequency.
To ensure that the function is not influenced by doorbells in the
320257_silv_Design-Funktuerklingel_content_US.indd 16
01.03.19 12:13
