LGMG AS0607E, Maintenance Manual

Page: 25 / 48

Maintenance Manual of Elevating Work Platform
20
switch will degrade the machine performance
and cause the potential unsafe working
environment
。
2) Be sure to complete the function inspection
on a solid and level ground without any
barrier
。
①
Switch the key switch to the ground
controller, and lift the platform for a
given height above the ground.
Model Height (m)
SS0407E 1.8
AS0607E 2.5
AS0812E 3.2
AS1012E 3.73
AS1212E
4
AS1413E
②
Lift the safety prop, move it to the center
of the scissor sleeve center and rotate it
upward until it is vertical.
③
Lower the platform height until the
safety prop completely contacts the
shaft sleeve.
△
! Warning: crush hazard

Be sure to put your hand on correct
position of the safety prop when
lowering the platform

Open the limit switch base cover on the
chassis
.

Slightly raise the platform and recover
the safety prop to the installation
position

Lift the platform via the ground controller,
while pressing the upper limit switch arm
to initialize the upper limit switch
Result: The platform stops rising and the
function of machine is normal.
Result: The platform continues to rise.
Adjust or replace the upper limit switch
B-16
Inspection of Steering knuckle
This check item shall be made once per 25h or
per month, whichever is shorter.
1) The condition of copper gasket of steering
knuckle is vital for the safe operation of the
machine. The use of worn copper gasket
may result in damage to component and
unsafe work risk.
2) Please check the copper gasket when the
platform is folded.
3) Measure the thickness of copper gasket.
a) Result:
If the measured result of SS0407E/AS0607E s
not greater than 10mm, replace the copper
gasket.
If the measured result of AS0812E/AS1012E/
AS1212E is not greater than 19mm, replace the
copper gasket.
b) Result:
If the measured result of SS0407E/AS0607E is