Operation Manual of Elevating Work Platform
25
6.13 Operation of Tilt Sensor
Test
△
!
Notice
This test is performed with the platform
controller from the ground. Do not stand
in the platform.
1) Completely lower the platform.
2) Drive two wheels on the same side of the
machine up on a 3.5×20cm block.
3) Lift up the platform to a height listed in the
following table. Result: The platform will stop
moving and the tilt alarm will sound at a rate
of 120 times per minute.
Table 6- Drive Cutout Height When Tilted
Model
Height (m)
AS0607
1.7
AS0607E
AS0607W
1.58
AS0607WE
SS0407E
2
SS0507E
AS0608
2.1
AS0608E
AS0808
AS0808E
AS1012
AS1012E
AS1212
AS1212E
SS0607E
2.6
AS0812
AS0812E
AS0612
1.45
AS0612E
AS1413
2.78
AS1413E
4) Slowly move the control handle to operate
drive forward and then driver reverse. Result:
The drive function will be disabled in either
direction.
5) Lower the platform and drive the machine off
of the blocks.
6.14 Pothole Guard Test
△
!
Notice:
When the platform is elevated, the
pothole guards will be automatically
deployed. The pothole guards initialize
another limit switch to enable the
continuous drive/steer operation of
machine. If the pothole guards fails to be
deployed, the alarm will sound and the
machine will stop all drive and steer
functions.
1) Lift the platform. Result: When the platform
elevates a given height (as shown in the
following table), the pothole guards shall be
deployed.
Table 7 - Pothole Deployment Height When Lifting
Model
Height (m)
SS0507E
2
SS0407E
AS0607
1.3
