58
6.2.4 Power Down Alarm
The
*POWER DOWN*
alarm is actuated when the device power supply falls
below a threshold value which does not guarantee flawless system operation
any longer.
In this state, the SPIN will immediately switch off the motor and store the
operating parameters in the permanent flash memory.
In this case, it is good rule to cut off the power supply to the device and check
that power supply voltage falls within the admitted values.
N.B.:
In the event of a Power Down occurrence, the device cannot be
switched off in manual mode. To reset the device, first disconnect it
from the power supply, then immediately reconnect it.
6.2.5 Display Alarms
These alarms are actuated by internal software errors. Please notify LGL
immediately if any of the following alarms is actuated.
When these alarms are actuated, the SPIN unit immediately switches off the
motor. They can only be reset by turning off the device (see chapter 5).
If the cause that actuated the alarm has not been removed upon turning on
the unit again, the alarm will be actuated again.
−
“Display Data”.
−
“Display Ctl”.
−
“Display Text”.
−
“Display Inv”.
6 - MESSAGES AND ALARMS
Summary of Contents for SPIN1
Page 2: ......
Page 6: ......
Page 13: ...13 1 GENERAL FEATURES 1 5 OVERALL DIMENSIONS 40 140 60 65 50 77 5 73 5 50 Weight 350 g...
