8
nstallation
I
Normal Tap without thread & screw type inlet hose
Normal Tap without thread & one touch type inlet hose
1
.
Unscrew the fixing screw to
attach the tap.
2
.
Push the connector up till the
rubber packing is in tight contact
with the tap. Then tighten the 4
screws.
3
.
Push the water supply hose
vertically upwards so that the
rubber packing within the hose
can adhere completely to the tap
and then tighten it by screwing it
to the right.
1
.
Loosen the upper connector
screw.
2
.
Push the upper connector up till
the rubber packing is in tight
contact with the tap. Then
tighten the 4 screws.
3.
Connect the water supply hose
to the middle connector,
pushing the plate down.
• Your machine comes with only
cold water connection.
• Make sure that there are no
kinks in the hose and that it is
not crushed.
• Make sure that the rubber seal
is inside the hose connector.
• In case the diameter of the tap is
large remove the guide plate.
• Turn the middle connector to
eliminate water leaked.
• To separate the water supply
hose from the middle connector
shut off the tap. Then pull the
inlet hose down, pushing the
plate down.
Rubber
packing
Rubber
packing
Rubber packing
Middle
connector
Middle
connector
Hose connector
Rubber seal
Rubber packing
Upper
Connector
Upper
Connector
Connector
Upper Connector
Upper
Connector
Upper
Connector
Plate
Plate
Guide Plate
Water supply hose
Water supply
hose
Upper Connector
Fixing screw
Fixing screw
Horizontal tap
Extension tap
Square tap
Used the horizontal tap
Summary of Contents for WD13050SD
Page 33: ...33 emo M ...
Page 34: ...34 emo M ...
Page 35: ...emo M 35 ...
Page 36: ...P No MFL31245155 ...