Installation Manual
37
ENGLISH
1. Two Thermistor System
(1) Open the rear cover of the wired remote-controller to set the mode.
(2) Select one of three selectable modes as follows.
•
Position 1: The room temperature is controlled by the thermistor of the main body.
•
Position 2: The room themperature is controlled by the thermistor of the wired remote-
controller, control the temperature according to the position of wired remote-
controller.
•
Position 3: The room temperature is controlled by lower temperature between the
temperature of main body and of remote-controller sensor.
(3) Move the slide switch to set position.
(4) Close the rear cover and check if it works normally.
CAUTIO
N:
•
Select the position after counselling with a customer.
•
In case of cooling mode, room temperature is controlled by the main body sensor.
•
To control the room temperature by a wired remote controller, install controller(room
temp. sensor) to sense the temperature more accurately.
•
Manufactured in the position 3.
Optional Operation
Optional Operation
TH
R14H
SW TH
REMO
MAIN
2TH
OP7
R18H
R17H
OP6
LO
STAND
SW
HIGH
HI
R03S
C070
R04S
R02S
R01S
OP3
OP2
OP1
R19H
R11H
R13H
R12H
OP5R16H
OP4
R15H
CO1H
REMO
Room Temp. sensor
2TH
MAIN
Position 2
Position 1
Position 3
Slide switch for ceiling height
Slide switch for 2 Thermistor
Summary of Contents for UU24
Page 43: ......
