INSTALLATION INSTRUCTIONS
73
ENGLISH
Installer Setting - Static Pressure Setting
This function is applied to only duct type. Setting this in other cases will cause malfunction.
Function Code
Pressure
Press the button for 3
seconds to enter the
Thermostat installer setting.
- If pressed for a shorter time,
it enters into user setup mode.
1
Select static pressure by pressing
buttons.
(01:V-H, 02:F-H, 03:V-L, 04:F-L)
3
Press button to save.
4
5
Press button to exit settings mode.
After setup, it automatically exits after 25
seconds if there is no input. If the
Setting/Cancel button is not pressed, the
mode will not change.
If pressing button repeatedly, it
moves to static pressure selection menu
as picture below.
2
Pressure selection
Function
Zone state ESP standard value
01 V-H Variable High
02 F-H Fixed High
03 V-L Variable Low
04 F-L Fixed Low
<Static Pressure Setting Table>
Summary of Contents for PREMTB10U
Page 94: ...94 ENGLISH ...
