LG LDV-S503, Owner'S Manual

Page: 19 / 80

19
5. Remove the HDD from the hard disk mounting
bracket.
6. Install the new HDD in the reverse order to when
replacing the hard disk drive.
7. After replacing the hard disk drive, insert the
power plug into the outlet and turn the power of
the unit on.
Notes:
• When you install or replace the HDDs to the
hard disk mounting bracket, you must set the
HDD jumper to slave or master.
You must install the HDD as shown below.
- Upper sides: Set the master HDD.
- Lower sides: Set the slave HDD.
• How and where to set the HDD jumper depends
on the manufacturer or model specification.
Therefore, carefully read the instructions printed
on top of the product or in the manual enclosed
with the product before installing the jumper.
- If the jumper pin settings are identical with
each other in terms of priority, either HDD may
not be detected in the DVR or malfunction
may occur.
• Make sure that each of the IDE cables is con-
nected to the connector housing through its holes.
• Do not stack them nor keep them upright.
• Do not use an electric screwdriver to fix them.
Recommended HDD
The following HDD has been tested and compatibility
is ensured. When you attach multiple HDDs use the
recommended HDDs.
Maker RPM Capacity Interface Model No.
Hitachi
7,200 80 GB
Ultra
ATA133
HDS728080PLAT20
7,200 160 GB HDT722516DLAT80
7,200 250 GB HDT722525DLAT80
7,200 320 GB HDT725032VLAT80
7,200 500 GB HDT725050VLAT80
Seagate
7,200 200 GB
Ultra
ATA100
ST3200827ACE
7,200 250 GB ST3250824ACE
7,200 300 GB ST3300822ACE
7,200 500 GB ST3500841ACE
HOOKUP AND
SETTINGS