36
Installation
Installation
3
[Primary Pass-Thru]
Select if you connect this unit’s DIGITAL
AUDIO OUT and HDMI OUT jack to a device
with LPCM, Dolby Digital, Dolby Digital Plus,
Dolby TrueHD, DTS and DTS-HD decoder.
NOTE
When [HDMI] option is set to [PCM Multi-Ch],
the audio may output as PCM Stereo if the PCM
Multi-Ch information is not detected from HDMI
device with EDID.
If the [Digital Output] option is set to [Re-
encode], the Re-encode audio is outputted for
BD-ROM discs with secondary audio and the
original audio is outputted for the other discs
(like [Primary Pass-Thru]).
•
•
Sampling Freq.
[192KHz]
Select this if your A/V Receiver or Amplifi er
is capable of handling 192 KHz signals.
[96KHz]
Select this if your A/V Receiver or Amplifi er
is NOT capable of handling 192 KHz signals.
When this choice is made, this unit
automatically converts any 192 KHz signals
to 96 KHz so your system can decode them.
[48KHz]
Select this if your A/V Receiver or Amplifi er
is NOT capable of handling 192 KHz and 96
KHz signal. When this choice is made, this
unit automatically converts any 192 KHz
and 96 KHz signals to 48 KHz so your system
can decode them.
Check the documentation for your A/V
Receiver or Amplifi er to verify its capabilities.
DRC (Dynamic Range Control)
When a content encoded in Dolby Digital or
Dolby Digital Plus is playing back, you may
wish to compress the dynamic range of the
audio output (the diff erence between the
loudest sounds and the quietest ones). This
allows you to listen to a movie at a lower
volume without losing clarity of sound. Set
[DRC] to [On] for this eff ect.
NOTE
The DRC setting can be changed only when a
disc is not inserted or the unit is in complete stop
mode.
Summary of Contents for HR500
Page 2: ......
