Dynamic V8
Air Cleaner Installation Manual
Dynamic V8 Air Cleaner
Air Cleaner Installation | 29
Air Cleaner Installation
For continual product development, LG reserves the right to change specifi cations without notice.
LG Electronics U.S.A. Inc., Englewood Cliffs, NJ. All rights reserved. "LG Life's Good" is a registered trademark of LG Corp./www.lghvac.com
6.
Flip the plenum assembly on its side with one edge of the top panel and the
edges of both end panels on the work surface. It does not matter which edge
faces the work surface.
7.
Select a side panel - they are identical. Lay the side panel selected on top of the
assembly with the raw edge facing down (toward the inside of the assembly).
Orient the side panel with the thin edge of the side panel closest to the top panel.
8.
In a similar fashion as done with the end panels, start at the outside corner of an
end panel, the outside corner is the one opposite the corner connected to the top
panel.
9.
Tilting the side panel, insert the corner into the snap lock seam slot on the end
panel aligning the side panel and end panel edges. Using the rubber mallet strike
the face surface of the side panel until the snap lock edge of the side panel is
recessed about half way into the seam slot of the end panel. The raised tabs
should still be visible.
Note:
Before fully mating the end and side panels, verify the long edge of the side panel aligns with the
slot on the long edge of the top panel. Adjust the side/end panel alignment if necessary to create square and
tight edge joints.
10.
Insert the raw edge of the side panel into the seam slot of the top panel begin-
ning at the end where the side panel is already half mated. Using the rubber
mallet work your way down the side and top panel seam half mating the panels
together as you go.
11.
Next, insert the raw edge of the remaining side panel to the seam slot of the
end panel. Begin at the corner of the end panel closest to the top panel. Using
the rubber mallet strike the face surface of the side panel is recessed fully in the
seam slot of the end panel.
12.
Using the rubber mallet and striking the face of the side panel along the edge,
fully mate the side panel with the current end panel.
13.
Complete the side panel installation by going back and fully mating the side
panel to the top panel and
fi
nally the other end panel. The side panel installation
is complete when the raised tabs on the side panel edge are engulfed by the op-
posing slot. The three edges of the side panel should
fi
t snug against the oppos-
ing panel edge without a gap between.
14.
Flip the assembly over so the side panel just mated is laying on the work surface.
Mate the remaining side panel to the assembly following the same procedure in
steps 8 to 14.
15.
If the duct con
fi
guration calls for the plenum to serve two (2) air cleaners, do not
install the plenum
fi
ller panel that came in the plenum kit. If the design calls for
the plenum connecting to only one (1) air cleaner, install the
fi
ller panel at this
time using
fi
eld provided #8 self tapping screws. Install screws with the heads
facing inside the plenum.
16.
Place the plenum assembly so one of the side panels is laying on the work
surface.
17.
Locate the strips of aluminum tape that came with the plenum.