LG AHBW Series, Installation Manual

Page: 66 / 81

System Set-Up
66 Air-to-Water Heat Pump
Code Item Detail Remark
12 Value #2 Note Lower limit of setting range(FCU is not equipped)
Default 16 °C
Range 16 ~ 18 °C
13 Function Setting air temperature in heating mode
Description Adjusting range of 'Setting Air Temperature' in heating mode
Value #1 Note Upper Limit of setting range
Default 30 °C
Range 24 ~ 30 °C
Value #2 Note Lower Limit of setting range
Default 16 °C
Range 16 ~ 22 °C
14 Function Setting leaving water temperature in heating mode
Description Adjustin range of 'Setting Leaving Water Temperature' in
heating mode
Value #1 Note Upper Limit of setting range
Default 55 °C
Range 35 ~ 57 °C
Value #2 Note Lower Limit of setting range
Default 15 °C (*20 °C)
Range 15 ~ 34 °C (*20 ~ 34 °C)
15 Function Setting sanitary tank leaving water temperature for
Sanitary water heating
Description Adjusting range of 'Setting Sanitary Tank Leaving Water Temperature'
in sanitary water heating mode
Value #1 Note Upper Limit of setting range
Default 50 °C
Range 50 ~ 80 °C
Value #2 Note Lower Limit of setting range
Default 40 °C
Range 30 ~ 40 °C
18 Function Screed drying mode
Description
After installing water pipes for under floor heating, user can select
screed drying mode for curing the cement
Value #1 Note
Default 01
Range 00 ~ 01
Value #2 Note
Default -
-
Range -
'Setting Air
Temperature' is
used when user
wants to set target
temperature by
room air
temperature.
'Setting Leaving
Water
Temperature' is
used when user
wants to set target
temperature by
leaving(from the
unit) water
temperature.
* : Electric heater
is not used
'Setting Sanitary
Tank Leaving
Water
Temperature' is
used when user
wants to set water
temperature of
Sanitary Tank.
00: Screed drying mode is not connected and not used.
01:Remote air sensor is connected and used.