6
ENG
ENGLISH
ASSEMBLING AND PREPARING
Using the Kensington security system
Using the FFC/IR PCB
The Kensington security system connector is
located at the back of the Monitor set. For more
information of installation and using, refer to the
manual supplied with the Kensington security
system or visit
http://www.kensington.com.
Connect the Kensington security system cable
between the Monitor set and a table.
y
y
The Kensington security system is optional.
You can obtain additional accessories from
most electronics stores.
NOTE
Portrait Layout
- Only on some models.
When installing in a Portrait Layout, rotate the
monitor clockwise 90 degrees (when facing the
screen).
Installing on a wall
Install the monitor at least 10 cm away from the
wall and leave about 10 cm of space at each side
of the monitor to ensure sufficient ventilation. De-
tailed installation instructions can be obtained from
your local retail store. Please refer to the manual
to install and set up a tilting wall mounting bracket.
If you intend to mount the monitor to a wall, attach
Wall mounting interface (optional parts) to the back
of the set.
When you install the monitor using the wall
mounting interface (optional parts), attach it
carefully so it will not drop.
1
Please, Use the screw and wall mount interface
in accordance with VESA Standards.
2
If you use screw longer than standard, the
monitor might be damaged internally.
1
Remove the securing tape first.
2
Do not pull out the FFC, as this may cause
damage.
3
Be careful not to damage the product during
installation.
10 cm
10 cm
10 cm
10 cm
10 cm
