LIP-8002/8002A
iPECS
Installer
Guide
5
3
Power
The LIP-8002 supports PoE. So, if the LAN port supports PoE, IEEE 802.3af
compliant, Class 2, the AC/DC adapter is not required. If not supported,
connect the IP Phone power port to the DC out of Power Adapter. Connect the
Power Adapter AC plug to an AC wall jack.
The LIP-8002A doesn’t support PoE. So, must connect the IP Phone power
port to the DC out of Power Adapter. Connect the Power Adapter AC plug to
an AC wall jack.
4
Handset Connect the Handset coiled cord to the IP Phone base and handset.
RJ-45 Pin Assignments
LAN
port
PC
port
Pin
1
=
TX+
Pin
1
=
RX+
Pin
2
=
TX-
Pin
2
=
RX-
Pin
3
=
RX+
Pin
3
=
TX+
Pin 4 = optional: 48V (or GND)
Pin 4 = No connection
Pin 5 = optional: 48V (or GND)
Pin 5 = No connection
Pin
6
=
RX-
Pin
6
=
TX-
Pin 7 = optional: GND (or 48V)
Pin 7 = No connection
Pin 8 = optional: GND (or 48V)
Pin 8 = No connection
Figure 2.1-2 RJ-45 Terminations
2.2 Wall Mounting
The LIP-8002/8002A incorporates wall mounting in the base of the phone housing. Using the
instructions below and Figure 2.2-1, wall mount the LIP-8002/8002A phone.
Mark and drill two 7 mm holes for plastic wall anchors with a vertical separation of 10 cm.
Insert two (2) anchors into the holes, then insert and tighten the two (2) screws leaving about
2.5 mm exposed. Refer to Figure 2.2-1.
Attach all wiring to the IP Phone as described in
section 2.1
.
Slide the IP Phone over the screws and assure the phone is secure. Note it may be
necessary to remove the phone and tighten or loosen the screws for a secure mounting.
Also note, the Foot Stand must not be attached to the IP Phone when wall mounting.
