LG-Ericsson iPecs GDC-500H, User Manual

Page: 27 / 68

GDC-500H Wireless Handset
User Guide
14
2. Press
[Digit 1]
(CONFIGURATION submenu), or
Select
[1. CONFIGURATION]
using Navigation up/down key and
[OK]
Button.
3. Press
[Digit 4]
(STATION REGISETR submenu), or
Select [1. STATION REGISTRATION] using Navigation up/down key and [OK] Button.
4. Press
[Digit 1]
(REGISTER STATION submenu), or
Select
[1. REGISTER STATION]
using Navigation up/down key and
[OK]
Button.
5. Select the phone type using Navigation left/right key (GDC-4XX)
6. Press Navigation
[OK]
button or
[OK]
soft key.
7. When the registration is completed below message is shown on LWS-BS LCD.
STATION: 10X
SUBSCRIBED: SUCCESS
Note:
Don’t press Monitor or Speaker button at the LWS-BS until the GDC-500H completes the
registration and registration confirmation tone is heard.
2.9.2 Registering to the LWS-BS
When registering to LWS-BS you will need the system’s unique Radio Frequency Personal
Identification (RFPI). Also, before starting the registration process make sure you are close
to an active LWS-BS.
To register to the system from the GDC-500H:
1. Press the Menu ( ) button to display the menu.
2. From the menu use the
Navigation
( ) button to highlight Phone Register.
3. Press the
OK
( ) button; this displays the Phone Register menu.
4. Select “LWS Subscription” using the up and down arrows of the
Navigation
( )
button and press the
OK
( ) button.
5. The GDC-500H searches for the LWS-BS, displaying and “Searching..1”. When a
LWS-BS is found, its RFPI, is displayed. The RFPI of your LWS-BS is available from
your System Administrator, or perhaps the attendant.
6. Press
OK
( ) button while highlighting the RFPI to continue the registration to the
system, or Press
No
( ) button to continue the search.
7. Press
OK
( ) button; on successful registration, a confirmation tone is received at
the GDC-500H and the LWS-BS.
8. If the registration fails, repeat procedure from Step 1 to 6 at the LWS-BS and Step 1 to
8 from the GDC-500H (refer to Note).
Note:
Depending on the LWS-BS or radio channel environment, the LWS-BS or the wireless
terminal may not recognize that the LWS-BS has the subscribed wireless terminal or the
wireless terminal is subscribed to the LWS-BS. Once a user has performed the subscription
procedure, the user should attempt to make a call. Then, if a user can’t make a call, the
subscription procedure should be conducted again after selecting the unsubscribe menu item
(refer to Terminating a Subscription section).
2.9.3 Terminating a registration from LWS-BS
Unsubscribing will make a wireless terminal lose connection to the LWS-BS. To unsubscribe
a wireless terminal, it should be in an idle state.