LG-Ericsson iPECS ES-4526G, User Manual

Page: 1140 / 1328

C
HAPTER
47
| IP Interface Commands
IPv6 Interface
– 1140 –
ES-4500G Series
◆
This command specifies the interval between transmitting neighbor
solicitation messages when resolving an address, or when probing the
reachability of a neighbor. Therefore, avoid using very short intervals
for normal IPv6 operations.
E
XAMPLE
The following sets the interval between sending neighbor solicitation
messages to 30000 milliseconds:
Console(config)#interface vlan 1
Console(config)#ipv6 nd ns-interval 30000
Console(config)#end
Console#show ipv6 interface
VLAN 1 is up
IPv6 is enabled.
Link-local address:
FE80::2E0:CFF:FE9C:CA10/64
Global unicast address(es):
2001:DB8:2222:7272::/64, subnet is 2001:DB8:2222:7272::/64
2009:DB9:2229::79, subnet is ::
Joined group address(es):
FF02::2
FF02::1:FF00:0
FF02::1:2
FF02::1:FF9C:CA10
FF02::1
IPv6 link MTU is 1500 bytes
ND DAD is enabled, number of DAD attempts: 2.
ND retransmit interval is 30000 milliseconds
Console#
R
ELATED
C
OMMANDS
show running-config (640)
ipv6 nd reachable-
time
This command configures the amount of time that a remote IPv6 node is
considered reachable after some reachability confirmation event has
occurred.
S
YNTAX
ipv6 nd reachable-time milliseconds
no ipv6 nd reachable-time
milliseconds - The time that a node can be considered reachable
after receiving confirmation of reachability.
(Range: 1000-3600000)
D
EFAULT
S
ETTING
30000 milliseconds is used for neighbor discovery operations
0 milliseconds is advertised in router advertisements
C
OMMAND
M
ODE
Interface Configuration (VLAN)