12
18. Adjust radius arm roller, if necessary (see illustration below).
Sometimes radius arm roller must be moved back to the next set of holes
and tip cut off.
19. Weld on brackets to protect hydraulic cylinder (see illustration below). With
platform in position shown (folded horizontal) weld platform brackets (angles-
supplied) to tension arms, so the platform is resting on brackets approximately
1/2” above cylinder. Weld solid down both sides as shown (1/4 fillet weld).
Caution:
Ground arms before welding brackets.
20. Trucks – Run 4 gauge power line from 150 amp circuit breaker (not supplied) or
gate starter solenoid to the truck battery.
Caution:
Make sure there is a ground
wire from battery to chassis.
21. Paint unit. Apply decals per diagram on page 15. Lubricate over-the-road latch
barrel and pin. Check hydraulic oil level in power unit tank when platform is on
the ground. Oil level should be about 1” from top of tank.
Summary of Contents for TSG Hide-A-Way
Page 5: ...5...
Page 7: ...7 TSG SILL CUTOUT...