30
Install memory, firmware, or option cards
Replacing the system board access
cover
After you have finished installing cards on
the printer system board, you must
replace the system board access cover.
1
Align the slots at the top of the
access cover with the screws near
the top of the printer.
2
Slide the cover up under the top
cover lip as far as it will go, and
then tighten the screws at the top
of the cover.
3
Insert and tighten the four screws
to the bottom of the cover.
If you installed a firmware card in your
printer, see the following section for
information about applying the Option
Added label.
Applying the Option Added label
The Option Added label alerts service
personnel that additional options have
been installed in your printer.
Follow the instructions in this section to
apply the Option Added label to your
printer.
1
Remove the backing from the
Option Added label.
2
Place the label on your printer next
to the printer model and serial
number label.
Summary of Contents for 752e - X MFP Color Laser
Page 2: ......
Page 3: ...English...
