Diagnostic aids
3-11
7013-
XXX
Input Tray tests
Feed Tests
This test allows you to observe the paper path of media as it passes through the printer. Any installed input tray
can be tested. The pages fed through the printer are blank.
To run the Feed Test:
1.
Select
INPUT TRAY TESTS
from Diag Menu, and press
Select
(
).
2.
Select
Feed Tests
, and press
Select
(
).
3.
Select the tray to be tested. Choices are installed trays, including Tray 1, Tray 2, and MP Feeder.
4.
Open the upper rear door to view the paper path.
Note:
Do not open the upper front door. The test will not run if the front door is open.
5.
Select
Single
or
Continuous
, and press
Select
(
).
•
Single—a single sheet of blank paper is fed, and the test stops.
•
Continuous—sheets are fed continuously until
Stop
(
) is pressed.
Output Bin Tests
The
Output bin tests
setting is used to test the printer’s output bins and its sensors.
Feed Tests
This test verifies that the media from the printer’s default input source feeds to the specific output bin. Press
to select
Single,
or press
and
to select
Continuous.
The
Single
test feeds one sheet of media to the
default output bin. No buttons are active during this test. The
Continuous
test feeds media to the default output
bin until
is pressed. The indicator light blinks green, and the operator panel displays
[Select Output Bin]
Feeding...
while either of these tests perform.
Sensor Test
This test verifies that the selected output bin’s sensors are working correctly. The following sensors are available
in each output bin:
Press
to select this test from the
Output bin tests
menu, and then press
again to select the desired
output bin.
Closed
will display on the operator panel if the sensor is closed.
Open
will display on the operator
panel if the sensor is open. If the wrong message is displayed, then the sensor is malfunctioning. To exit the
Sensor Test
, press
or
.
Output bin
Full sensor
Near full sensor
Passthru 1
sensor
Passthru 2
sensor
Level sensor*
Standard bin
✔
x
x
x
x
-bin Mailbox
x
x
✔
✔
✔
*This sensor will register the following levels: “empty,” “normal,” “near full,” and “full.
All manuals and user guides at all-guides.com
Summary of Contents for 363dn - X B/W Laser
