65
Port Trunk - State Activity
When you had setup the LACP aggregator, you can configure port state activity. You can
mark or un-mark the port. When you mark the port and click
Apply
button the port
state activity will change to
Active
. Opposite is
Passive
.
Active:
The port automatically sends LACP protocol packets.
Passive:
The port does not automatically send LACP protocol packets, and
responds only if it receives LACP protocol packets from the opposite device.
Note
1. A link has either two active LACP ports or one active port can perform
dynamic LACP trunk.
2. A link has two passive LACP ports will not perform dynamic LACP trunk
because both ports are waiting for an LACP protocol packet from the
opposite device.
3. If you are active LACP’s actor, after you have selected trunk port, the active
status will be created automatically.
Port Trunk – State Activity interface
Port Mirroring
Summary of Contents for GSW-0891
