Leuze 50143209, Original Operating Instructions

Page: 22 / 71

Mounting
Leuze electronic GmbH + Co. KG BCL 208i 22
5 Mounting
5.1 Transport and storage
NOTICE
Ä
Package the device for transport and storage in such a way that is protected against shock
and humidity. Optimum protection is achieved when using the original packaging.
Ä
Ensure compliance with the approved environmental conditions listed in the specifications.
Unpacking
Ä Check the packaging content for any damage. If damage is found, notify the post office or shipping
agent as well as the supplier.
Ä Check the delivery contents using your order and the delivery papers:
• Delivered quantity
• Device type and model as indicated on the name​plate
• Package insert
The name plate on the bottom of the device provides information as to what BCL type your device is, see
chapter 13 "Technical data".
Ä
Save the original packaging for later storage or shipping.
Ä
If you have questions, please contact your supplier or Leuze customer service, see chapter 12 "Service
and support".
Ä
Observe the applicable local regulations when disposing of the packaging materials.
5.2 Mounting
The bar code reader can be mounted in the following ways:
• Mounting with four M4x5 screws on the rear side of the housing.
• Mounting with mounting devices on the fastening groove on one side of the housing.
NOTICE
Ä When mounting, ensure that the scanning beam is not reflected directly back to the scanner
by the label which is being read. For further information, see the notes in see chapter 5.3
"Selecting a mounting location".
Ä
Please refer to see chapter 13.2 "Reading fields" for the permissible minimum and maximum
distances between the bar code reader and the labels to be read.
5.2.1 Mounting with M4 fastening screws
Ä
Mount the device on the system with M4 fastening screws (not included in delivery contents).
ð Max. tightening torque of the fastening screws: 2.5 Nm
ð
Location and thread depth of the mounting thread: see chapter 13.3 "Dimensioned drawings"
5.2.2 Mounting with BT 56 or BT 56-1 mounting device
Mounting with the mounting device is intended for rod mounting.
Order guide: see chapter 14.4 "Accessories – mounting systems"
Ä Mount the mounting device on the rod with the clamp profile (system-side).
Ä
Mount the device on the mounting device using the fastening grooves.
ð
Max. tightening torque of the fastening screws: 1.4 Nm