Leuze electronic DCR 55, Operating Instructions Manual

Page: 57 / 94

Configuration control
Leuze electronic DCR 55 57
Code Description Command Format Op-
tions De-
fault Notes/Examples
AGC Low Quality time limit AG TM S/P/R/
G LQ 120 AGC Low Quality time limit
Valid Range:
Example : AGTMSLQ120
Timeout multiplier (FP24_8) AG TM S/P/R/
G MT 0x100 Timeout multiplier (FP24_8)
Valid Range:
Example : AGTMS
8.2.13 Setup motion detection parameters
Code Description Command Format Op-
tions De-
fault Notes/Examples
Get All motion detect set-
tings MD PM G Returns all motion detection parameter
values in an XML element.
Example : MDPMG
Minimum Illumination MD PM S/P/R/
G NI 0 0 Minimum Value
This is the lowest value the AGC should
use to set the illumination.
Valid Range: 0 to Maximum illumination
Example : MDPMSNI1
Maximum illumination MD PM S/P/R/
G XI 6 100 Maximum Value
This is the highest value the AGC
should use to set the illumination.
Valid Range: Minimum illumination to
100
Example : MDPMSXI0
Initial illumination value MD PM S/P/R/
G II 1 The starting value the AGC will use to
start adjusting illumination.
Valid Range: Minimum illumination to
Maximum illumination
Example : MDPMSII1
Minimum exposure time (µs) MD PM S/P/R/
G NE 1 1 Minimum Value
Valid Range: 1 to Maximum exposure
time microseconds
Example: MDPMSNE100
This is the minimum time the camera
lets light into the element to take the pic-
ture in microseconds.
Maximum exposure time
(µs) MD PM S/P/R/
G XE 46 200
00 Maximum Value
Valid Range: Minimum exposure time
to 20000 microseconds
Example: MDPMSXE10040
Initial exposure time (µs) MD PM S/P/R/
G IE 40 Valid Range: Minimum exposure time
to Maximum exposure time microsec-
onds
Example : MDPMSIE100