Step 12:
Step 13:
Step 14:
Apply Weather Striping [
N
] to each end of the HexCap Body Cover [
A
]. [Figure 22]
Secure the Weather Stripping [
N
] to the Cover [
A
] by driving the Weather Stripping Tex Screws (LG) [
P
] through the
Weather Stripping and into the Cover. [Figure 23]
Connect two (2) Cover Bands [
Q
] together using the supplied Cover Band Spring [
R
].
[Figure 24]
Repeat this Step with the remaining Cover Bands [
E
] and Spring [
R
] creating two
complete Cover Band Assemblies.
Make sure the Latches are engaged and in the locked position.
Working with only one (1) Joint connector bolt at a time.
Remove one (1) Joint Connector Bolt from ends of each
Bulk Head [
B & C
] and then re-install the Joint Connector Bolt securing one end of the Cover Band Assembly [
Q & R
] to
the edge of the Cover. [Figure 25 & 26]. Repeat this Step for the remaining three corners of the HexCap Cover to fully
secure each Cover Band.
NOTE:
The Cover Band should overlay the Weather Stripping [
N
] by approximately 1/4in.
TOOL REQUIRED: 5/32in Hex Key
TOOL REQUIRED: Drill; Philips Head Driver
N
P
Q
Q
Q
R
R
N
N
A
JOINT
CONNECTOR BOLT
JOINT
CONNECTOR BOLT
Page 6 of 7
[Figure 22]
[Figure 24]
[Figure 25]
[Figure 26]
[Figure 23]
