Step 8:
Step 9:
IMPORTANT - THIS STEP REQUIRES TWO PEOPLE FOR PROPER INSTALLATION.
Lift and hold open the HexCap Cover open. Locate the pair of holes on each side of the HexCap Cover. Using the
Screws and Washers included on the Bracketed Ball Stud [
G
], insert the Button-Head Bolts and one (1) washer through
the
outside
of the trailer. [Figure 12 & 13]
On the
inside
of the trailer, secure the Bracketed Ball Stud [
G
] to the trailer using the Ball Stud Spacer [
H
] and the
remaining Washers and Nuts from the Bracket Ball Stud Assembly as shown. [Figure 14]
Repeat this process for the other side of the trailer.
NOTE:
This connection is a tight fit.
IMPORTANT - THIS STEP REQUIRES TWO PEOPLE FOR PROPER INSTALLATION.
From the front of the trailer locate the #5 U-Tube. Measure 1in across and 1in down and mark this spot. Drill a hole using
a dill with a 5/16in drill bit in the marked location. [Figure 15 & 16]
On the
inside
of the trailer, insert one (1) Ball Stud [
J
] with two (2) of the attached Washers into the newly made hole.
On the
outside
of the trailer, secure the Ball Stud with the remaining Washers and the included Nut as shown.
[Figure 17]
Repeat this process for the other side of the Trailer.
1
2
3
4
5
6
7
8
Top of Trailer
#5 U-T
ube
1in
1in
TOOL REQUIRED: Drill; 5/16in Hex Driver; 1/2in Wrench
TOOL REQUIRED: 3/8in Wrench; Philips Head Screw Driver
BRACKETED BALL
STUD ASSEMBLY
BRACKETED BALL
STUD ASSEMBLY
BRACKETED BALL
STUD ASSEMBLY
BRACKETED BALL
STUD ASSEMBLY
G
H
BALL STUD
ASSEMBLY
BALL STUD
ASSEMBLY
J
Page 4 of 7
[Figure 12]
[Figure 15]
[Figure 16]
[Figure 17]
[Figure 13]
[Figure 14]
