Leroy Merlin J1G-ZP2A-190, Assembly, Use, Maintenance Manual

Page: 106 / 118

EN
1. Make sure that the electrical plug is removed from the power point.
2.Push the saw arm (1) down to its lowest position and engage the release knob (2) to hold
the saw arm in the transport position.
3. Loosen the mitre locks (15).
4. Rotate the table (12) until the pointer is positioned at 0º.
5. Tighten the mitre locks (15).
6. Loosen the bevel lock (7) and set the saw arm (1) at 0º bevel (the blade at 90º to the mitre
table). Tighten the bevel lock (7).
7. Place a set square against the table (12) and the flat part of the blade.
8. Rotate the blade by hand and check the blade-to-table alignment at several points.
9. The edge of the set square and the saw blade should be parallel.
10. If the saw blade angles away from the set square, adjust as follows.
11. Use a 8 mm wrench or adjustable wrench to loosen the lock nut securing the 0° bevel
adjustment screw (10). Also, loosen the bevel lock (7).
12. Adjust the 0° bevel adjustment screw (10) using a 4 mm hex key to bring the saw blade
into alignment with the square.
13. Loosen the Phillips head screw holding the pointer of the bevel scale (8) and adjust the
position of the pointer so that it accurately indicates zero on the scale. Retighten the screw.
14. Retighten the bevel lock (7) and the lock nut securing the 0° bevel adjustment screw
(10).
SETTING THE TABLE SQUARE WITH THE BLADE
1. Loosen the bevel lock knob (7) and tilt the cuttinghead completely to the left.
2.Using a combination square, check to see if the bladeis at a 45° angle to the table.
3 If the blade is not at 45° to the mitre table, tilt thesaw arm to the right, loosen the lock
nut on the 45° Bevel adjustment screw (9) and use a 4 mm hex wrench to adjust bolt depth
in or out to increase or decrease the bevel angle.
4 Tilt the cutting arm to the left to 45° bevel andrecheck for alignment.
5.Repeat steps until the blade is at 45° to the mitretable.
6.Tighten bevel lock knob (7) and locknut on the 45° Bevel adjustment screw (9) when
alignmentis achieved.
45° BEVEL ADJUSTMENT
SETTING THE FENCE SQUARE WITH THE TABLE
1. Make sure that the electrical plug is removed from the power point.
2. Push the saw arm (1) down to its lowest position and engage the release knob (2) to
hold the saw arm in the transport position.
3. Loosen the mitre locks (15).
4. Rotate the table (12) until the pointer is positioned at 0º.
5. Tighten the mitre locks (15).
6. Using a 5 mm hex key, loosen the two screws securing the fence (11) to the base.
105