Residual hazards
Even if notes given are taken into consideration and protective measures are implemented, the occurrence
of residual risks cannot be fully prevented.
The user must take the residual hazards mentioned into consideration in the risk assessment for his/her
machine/system.
If the above is disregarded, this can lead to severe injuries to persons and damage to property!
Product
Observe the warning labels on the product!
Icon
Description
Electrostatic sensitive devices:
Before working on the product, the staff must ensure to be free of electrostatic charge!
Dangerous electrical voltage
Before working on the product, check if no voltage is applied to the power terminals!
After mains disconnection, the power terminals carry the hazardous electrical voltage given on the product!
High leakage current:
Carry out fixed installation and PE connection in compliance with EN 61800−5−1 or EN 60204−1!
Hot surface:
Use personal protective equipment or wait until the device has cooled down!
Protection of persons
•
The product does not provide safety-related functions.
-
A higher-level safety system must be implemented.
-
Additional monitoring and protective equipment complying with the safety regulations applicable in
each case must be used.
•
The power terminals may carry voltage in the switched‐off state or when the motor is stopped.
-
Before working, check whether all power terminals are deenergised.
•
Voltages may occur on the drive components (e.g. capacitive, caused by inverter supply).
-
Careful earthing in the marked positions of the components must be carried out.
•
Risk of burns may be caused by hot surfaces!
-
Provide for a protection against accidental contact.
-
Use the personal protective equipment or wait until the components have cooled down completely!
-
Prevent contact with flammable substances.
•
There is a risk of injury due to rotating parts.
-
Before working on the drive system, ensure that the motor is at a standstill.
•
There is a danger of unintentional starting or electrical shocks!
•
Installed brakes are no fail-safe brakes.
-
The torque may be reduced by disruptive factors that cannot be influenced such as ingressing oil.
Safety instructions
Residual hazards
48