Lenze ESV112N01SXB571, Operating Instructions Manual

Page: 37 / 48

35
EDBSV571 EN 1.0
EN
Commissioning
Modbus Reg. Name Access Type Range of adjustment Important
2006 Drive Load Read only 0-255 [%] Motor load as % of drive’s output
current rating (P507)
2007 Output Power Read only 0-655.00 [0.01 KW]]
2008 Heatsink
Temperature Read only 0-150 [°C]
2009 DC Bus Voltage Read only 0-1500 [VDC]
2010 Digital Inputs Read only Word representing
misc. binary statuses See reference below
2011 Actual Torque Read only 0-500% Torque as % of motor rated torque
(vector mode only)
2012 Actual Setpoint
Frequency Read only 0 – 65535 [0.1Hz] Resolution 0.1Hz (ex. 345 – 34.5Hz)
2013 Reserved Read only 0 – 0xFFFF
2014 Reserved Read only 0 – 0xFFFF
2015 Reserved Read only 0 – 0xFFFF
2016 Reserved Read only 0 – 0xFFFF
2017 Reserved Read only 0 – 0xFFFF
2018 Reserved Read only 0 – 0xFFFF
2100 Drive Control Word Read/Write 0 – 0xFFFF
See bit details below
2101 Network Frequency
Setpoint Read/Write 0 – 65535 [0.1Hz] Resolution 0.1Hz (ex. 345 – 34.5Hz)
2102 Network Analog
Output Read/Write 0 – 1000 [0.01 VDC] Sets the output voltage level at
terminal Tb30. P150 must be set to 9
‘Network Control’
2103 Digital/Relay Output Read/Write Reserved Reserved – User controlled digital
output and relay are not available
2104 Network PID
Setpoint Read/Write P204…P205 Min/max user feedback scaling
Signed Feedback Display Units
2105 Network PID
Feedback Reference Read/Write P204…P205 Min/max user feedback scaling
Signed Feedback Display Units
2106 Network Torque
Setpoint Read/Write 0-100%
2107 Trigger Network
Fault Read/Write 0-9 Writing into this register triggers drive
fault ‘F.Fn1…9.
To clear it, first write 9 into this register.
2108 Override Display Dig
1 and 2 Read/Write 0-0xFFFF High byte represents the 8 LED
segments of digit 1 of Drive display.
Low byte represents the 8 LED
segments of digit 2 of Drive display.
2109 Override Display Dig
2 and 3 Read/Write 0-0xFFFF High byte represents the 8 LED
segments of digit 3 of Drive display.
Low byte represents the 8 LED
segments of digit 4 of Drive display.
After writing this register (2009), if both
values in reg. 2108 and 2109 are not
equal 0 the Drive display will switch
to display the override value. See note
below with example.
2110 Reserved Read/Write 0-0xFFFF