47
E
Change to "PoM"
Select CV7
Program the value 50 into CV7. This switches the LZV200 into
setting mode; again, the LED of the LZV200 shows a double-flash.
You have 15 seconds to program the value 92 for deactivating the
RailCom function into CV7. Again, the LED will shine constantly
and RailCom is deactivated.
10 The LED display
The various operating states of the LZV200 are indicated by the upper
LEDs on the front panel, the state of the built-in amplifier is indicated
by the lower LED.
During normal operation, both the upper and lower (red) LEDs are
permanently on.
10.1 Indication of the upper LEDs
The red LED is permanently on during operation of the LZV200.
If the green LED lights up, the LZV200 is connected to a computer via
the USB interface. The yellow LED flickers when there is data traffic
between the LZV200 and the PC.
10.2 Indication of the lower LED
LED shines constantly Everthing ok, device in normal operation
LED flashes slowly
Short-circuit on the track system, track voltage
switched off
or
Distribution voltage too low (due to the load
being too high)
or
Emergency stop, track voltage switched off at
the operating device
LED flashes quickly
Short-circuit on the track system, overheating
of.
LED double-flashes:
A programming procedure was started by
means of PoM (see “Setting the voltage on
the track”)
