Lenovo ThinkSystem 4350 Series, Installation And User Manual

Page: 24 / 38

Figure 11. Connecting cables between the adapter and storage devices
Step 7. Replace the cover and reconnect any cords and cables, and power up the system. Replace the
chassis’s cover, reconnect any power cords, and reconnect network cables. Turn on the power.
Step 8. Boot to system F1 Setup and run the Human Interface Infrastructure (HII) Configuration Utility to
make any desired configuration changes.
Installing RAID super capacitor module
This section describes how to install the super capacitor module of ThinkSystem RAID 9350 Series adapters
on the chassis. The super capacitor module can also be installed on an air baffle, a riser, or an 2.5–inch
middle drive cage (if any), depending on your server model and requirement. For details about how to install
it on the other locations, go to
Install a RAID super capacitor module
of your server document.
Attention: Prevent exposure to static electricity, which might lead to system halt and loss of data, by
keeping static-sensitive components in their static-protective packages until installation, and handling these
devices with an electrostatic-discharge wrist strap or other grounding system.
Procedure
1. Touch the static-protective package that contains the new RAID super capacitor module to any
unpainted surface on the outside of the server. Then, take the new RAID super capacitor module out of
the package and place it on a static-protective surface.
2. Install the super capacitor module.
20
ThinkSystem 4350/5350/9350 Series Adapters Installation and User Guide