interference with reinstalling the server cover.
4.
Position the server cover on the chassis so that the rail guides on the bottom of
the server cover engage the rails on the chassis. Then, slide the cover to the
front of the server until it snaps into position.
5.
Install the screws to secure the server cover.
6.
Lock the server cover if you have a server cover lock. See “Integrated cable
lock” on page 46 or “Padlock” on page 47.
7.
Reconnect the external cables and power cords to the server. See “Front view”
on page 11 and “Rear view” on page 12.
8.
Depending on the parts you installed or replaced, you might need to confirm
the updated information in the Setup Utility program. Refer to Chapter 6,
“Configuring the server,” on page 49.
Note:
In most areas of the world, Lenovo requires the return of the defective
Customer Replaceable Unit (CRU). Information about this will come with the CRU
or will come a few days after the CRU arrives.
Updating the server configuration
When you start the server for the first time after you install or remove an internal
option or external device, you might receive a message that the configuration has
changed. The Setup Utility program starts automatically so that you can save the
new configuration settings.
Some options have device drivers that you must install. For information about
installing device drivers, see the documentation that comes with each option.
Figure 33. Reinstalling the server cover
Chapter 5. Installing or replacing customer replaceable units
45
Summary of Contents for 098118U
