background image

Page 1

PRODUCT LITERATURE

1995 Lennox Industries Inc.

Dallas, Texas

ÎÎÎ

HP25 HEAT PUMP UNIT

HP25 heat pump units are designed for expansion valve

systems only. They are not designed for RFC systems.

Refer to Lennox engineering handbook for expansion

valve kits which must be ordered separately.

SHIPPING AND PACKING LIST

 1- Assembled HP25 heat pump unit
Check unit for shipping damage. Consult last carrier

immediately if damage is found.

GENERAL INFORMATION

These instructions are intended as a general guide and

do not supersede national or local codes in any way.

Authorities having jurisdiction should be consulted be

fore installation.

IMPORTANT

The Clean Air Act of 1990 bans the intentional

venting of refrigerant (CFC's and HCFC's) as of July

1, 1992. Approved methods of recovery, recycling

or reclaiming must be followed. Fines and/or in

carceration may be levied for non-compliance.

INSTALLATION

INSTRUCTIONS

HP25 SERIES UNITS

HEAT PUMP UNITS

503,302M

6/95

Supersedes 503,247M

TABLE OF CONTENTS

HP25 HEAT PUMP UNIT

1

. . . . . . . . . . . . . . . . . . . . . . . . . . . . 

SHIPPING AND PACKING LIST

1

. . . . . . . . . . . . . . . . . . . . . . 

GENERAL INFORMATION

1

. . . . . . . . . . . . . . . . . . . . . . . . . . 

HP25 UNIT DIMENSIONS

2

. . . . . . . . . . . . . . . . . . . . . . . . . . 

HP25 PARTS ARRANGEMENT

3

. . . . . . . . . . . . . . . . . . . . . . 

SETTING THE UNIT

3

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 

ELECTRICAL

4

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 

PLUMBING

5

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 

REFRIGERATION

5

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 

LEAK TESTING

6

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 

EVACUATION

6

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 

START-UP

7

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 

CHARGING

7

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 

SYSTEM OPERATION

9

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 

DEFROST SYSTEM

9

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 

MAINTENANCE

11

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 

HP25 CHECK POINTS

12

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 

RETAIN THESE INSTRUCTIONS

FOR FUTURE REFERENCE

WARNING

Product contains fiberglass wool.
Disturbing the insulation in this product during

installation, maintenance, or repair will expose

you to fiberglass wool. Breathing this may cause

lung cancer. (Fiberglass wool is known to the

State of California to cause cancer.)
Fiberglass wool may also cause respiratory, skin,

and eye irritation.
To reduce exposure to this substance or for further

information, consult material safety data sheets

available from address shown below, or contact

your supervisor.

Lennox Industries Inc.

P.O. Box 799900

Dallas, TX 75379-9900

Litho U.S.A.

Summary of Contents for HP-511-513













Reviews: