6.
Position the flywheel back in place on the bike frame.
•
Lift the flywheel up and position it on the frame with the shiny side of the pillow blocks facing
up. Apply
1-2 drops of Loc-Tite
®
242
on each of the pillow block mounting screws threads
before threading them into the bike. Secure the flywheel to the bike using four pillow block
mounting screws.
Tighten the bolts in a cross-pattern sequence.
7. Re-install the belt.
•
Re-install the belt around the front pulley, under the idler pulley, and around the top side of the
rear pulley of the bike. Once in this position, the belt can be installed the rest of the way simply
by rotating the pedals backwards. Tension the belt by tightening the idler tension screw on top of
the idler pulley. Tighten the idler pulley nut.
WARNING: WATCH YOUR FINGERS AS YOU
INSTALL THE BELT ON THE PULLEYS SO THAT YOU DO NOT PINCH THEM BETWEEN THE
PULLEY AND THE BELT.
8
. Test the belt tension.
•
Stand on the pedals with the pedals horizontal to the floor. Pedal quickly and see if the belt slips.
A minimum of slipping is okay, it is important not to over-tighten the belt.
9.
Re-install the right side cover on the bike.
•
Install 4 cover screws on the right side cover.
•
Install 2 cover screws on the left side cover.
10.
Test the bike.
•
Ride the bike to test and make sure that no abnormal noise is heard and that the bike functions
properly. While the flywheel is in motion, push down on the brake and verify that the flywheel
stops correctly.
For telephone assistance, please contact your local distributor or the Customer Service Department of LeMond Fitness
Inc.. at 1-425-482-6773 x109 from 0800AM – 1700PM PST
Monday through Friday.
©2002 LeMond Fitness Inc., RevMaster, and LeMond are registered trademarks
