19
5
THREE POINT LINKAGE
5.1
General Instruction
The category of the three point linkage must be the same at the tractor and
the implement. If this is not the case, either the tractor three point linkage
must be adapted or the drawbar (A0) and if required the top link pin ex-
changed by a category corresponding version.
5.2
Three Point Linkage
The category of the three point
linkage must be the same with the
implement as well as with the trac-
tor. If there is no correspondence,
either the three point linkage of the
tractor must be adapted or the dra-
wbar (A0) and if required the top
link pin must be replaced by a cor-
resonding version.
The maximum allowered tractor po-
wer and measurements accoring to
to ISO 730-1 can be learned from
the following table:
kW (HP)
Cat.
Diameter
of the pi-
vot of the
drawbar,
mm
Length of the
drawbar,
mm
(collar dis-
tance)
Distance
of the
tractor lo-
wer links,
mm
Distance between
drawbar and the
point of intersec-
tion of the lower
links, mm
(1)
(2)
(3)
(4)
bis 92 (125)
II
28
825
390-505
1800-2400
80-185 (109-251)
II/III
36,6
825
390-505
1800-2400
80-185 (109-251)
III
36,6
965
480-635
1900-2700
150-350 (204-476)
III/IV
50,8
965
480-635
1900-2700
150-350 (204-476)
IV
50,8
1166
480-660
1900-2800
Summary of Contents for Thorit 9 K
