15
- Do not use parts or filters of the appliance for other purposes.
- Do not suck warm water.
- Do not store or use the appliance in moist places.
- Do not use the appliance for cleaning the stairs.
- Only use the appliance in vertical position; if the appliance has been dropped to the ground, immediately stop
sucking and remove the plug from the wall socket.
- Absolutely avoid overturning or dropping down the appliance during its use.
APPLICATIONS & PRIOR TO OPERATION
1. Application
This appliance is intended for sucking up dry, non-flammable dusts and liquid.
2. Power source check
Ensure that the power source to be utilized conforms to the power requirements specified on the product
nameplate.
3. Switch status check
Ensure that the power switch is in the OFF position. If the plug is connected to a power receptacle while the
power switch is in the ON position, the appliance will start operating immediately, which could cause a serious
accident.
4. Electrical safety
The electric motor has been designed for one voltage only. Always check that the power supply corresponds to
the voltage on the rating plate.
ASSEMBLY AND INTRODUCTION
CAUTION!
To prevent accidents, make sure to turn the switch off and disconnect to the plug from the power receptacle.
Connection (Fig 1)
- Insert the flexible hose end (1) into the air inlet connector (12).
- Insert the telescopic metal tube (8) into the handle (7) at the other end of the flexible hose, according to the
desired length of the handle.
- Choose the final accessory which you like to use and insert it to the other end of the metal tube (8).
Use the right accessories according to different situation.
Installing/changing the cartridge filter (Fig 2)
- Unlock the closing hooks (4) and take off the motor body (3).
- Make sure that the tank is clean and perfectly dry.
- Carefully remove the cartridge filter (15) from the filter rack.
- Clean and check the filter seal; replace it if necessary.
- Check the floating valve (21) for proper operating.
- Correctly insert the new cartridge filter (15), perfectly dry and clean, onto the filter rack until it is completely
covered.
- Put back the motor body (3) on the containing trunk (13), and lock the motor body with both closing hooks (4).
NOTE:
After picking up liquids, the cartridge filter is wet. A damp filter element clogs more quickly when dry substances
are picked up. For this reason the cartridge filter should be washed and dried or replaced by a dry one before dry
substances are picked up.
CAUTION!
Never use the vacuum cleaner without a filter.
Installing/changing the dust bag (Fig 3)
Before picking up dry substances, always ensure that a filter bag is inserted in the tank. Disposal of the picked up
material is then simple and hygienic.
- Unlock the closing hooks (4) and take off the motor body (3).
- Make sure that the tank is clean and perfectly dry.
GB
