SAFETY
E-LINK D
6060 •
D
4060
9
Electrical equipment/Electronics
Operation with other onboard power supplies is not
permissible! Prior to any kind of assembly, adjustment and
maintenance work, the E-Link system must be
disconnected from power supply (switch off control voltage
on switch box).
Check correct setting of all sensors regularly and check that
all sensors and actors are tightened properly.
Power supply of the electronics must only be switched on
when the machine is to be operated. After the end of work,
the control system must immediately be disconnected from
power supply.
It is not permissible to enter the working range of the
machine or to approach the working range of the machine
as long as the electronics are supplied with power.
During cleaning work, the electronics must not be exposed
to a direct water jet (in particular: high-pressure cleaning
machine).
The existing wiring of the E-Link and of the respective
machine may only be used for the consumers installed in
the factory and approved by the manufacturer.
E-Link is designed exclusively for 12-volt operation.
Welding work
Do not permit welding current to flow through the E-Link
system.
Provide for all-polo disconnection of the power supply to the
machine (disconnect battery).
Interrupt power supply between tractor and baler.
Take strong heat generation at welding points into account.
Dismount sensitive parts (cables, sensors, plastic parts)
before welding.