innovators in agriculture
EN-15
7 MAINTENANCE
• Correct machine servicing is vital for ensuring reliable
and safe operation.
7.1
Maintenance after operation
- Clean the machine thoroughly.
- Grease the machine with an anti-corrosion agent.
Pay special attention to the tines. Smooth tines without any rust
stimulate an unhampered crop flow.
- Grease the piston rods with an anti-corrosion agent if the machine
will not be used for a long period.
Remove the agent before using the machine again. If this is not
done, the seals of the rams may be damaged when the anti-
corrosion agent hardens.
7.2
Lubrication
All lubrication points of the machine can be greased with a
biodegradable grease (Total Biomultis SEP2), unless stated
otherwise.
- PTO shafts must be greased every 8 working hours via the grease
nipples on the cross assemblies, protection tubes and slip clutch
(fig. 16).
- Grease the profiled tubes of the PTO shaft every 8 working hours
(fig. 16).
- Gears in the gearbox over the rotor must be greased every 8
working hours (fig. 17). While greasing, keep turning the rotor bit
by bit to ensure the grease is distributed effectively all over the
gears.
!
16
8 h
8 h
17
8 h
Summary of Contents for 1015 CD Profi
Page 2: ...innovators in agriculture...
Page 4: ...EN 2 innovators in agriculture...
