24
MaraX
- PL62X*
e. Run a backflushing procedure to clean the essential parts of your coffee machine,
see the chapter 15.
5. The coffee cream is not thick
a. Following the steps of a correct coffee extraction, try to select a higher temperature
range by pressing the 3-position switch (9).
b. Select a suitable coffee blend knowing that a thick cream needs a good percentage
of Robusta: read more about this in chapter 12.
6. The hot water wand leaks
a. Follow the instructions below:
1. Turn ON the machine and wait until the steam manometer indicates the pressure.
Place a jug under the leaking wand and turn OFF the machine. Take care to avoid
contact with water sprays.
2. Open the water knob and let the hot water come out completely.
3. Close the tap and turn ON the machine.
4. Check the water wand: if the leaking persists, run a descaling procedure (contact
your reseller for more details this regards).
5. If the leaking still persists, contact your reseller to have the machine checked and repaired.
7. No steam from the steam wand
a. Follow the instructions below:
1. Check the pressure indicated on the steam pressure manometer: if there is no
pressure, turn the machine OFF and ON and wait 10 minutes.
2a. If the manometer registrates no pressure, contact your reseller for check and repair.
2b. If the manometer registrates pressure, remove the wand tip and release some
steam without the tip: if the steam comes out regularly, it means that the tip is blocked.
Close the steam tap and clean the tip properly: make sure the holes are free.
3. Reassemble the tip on the steam wand.
8. No hot water from the water wand
a. Follow the instructions below:
1. Check the pressure indicated on the steam pressure manometer: if there is no
pressure turn the machine OFF and ON and wait 10 minutes.
2a. If the manometer registrates no pressure, contact your reseller for check and repair.
2b. If the manometer registrates pressure, remove the water aerator and release
some hot water without the aerator: if the water comes out regularly, it means that the
aerator is blocked.Close the water tap and clean the aerator properly.
3. Reassemble the part on the water wand.
